Summit Lifting Devices · a division of Sharrow Lifting Products
Custom below-the-hook devices
Three of our devices draw themselves on this site. The rest start with a conversation — send a drawing, a CAD file, or a photo of a sketch on a napkin, and our engineer will tell you what it takes to build it.
What custom usually means
The ones that never fit a catalogue
Sixty years of below-the-hook work, and the jobs that come to us are the ones nobody publishes a part number for. If yours is on this list, or nothing like it, send what you have.
C-hooks and coil handling
Coils, reels and anything that has to be picked from the eye rather than the top.
Sheet, plate and panel
Vertical and horizontal plate clamps, sheet lifters, panel frames for an awkward footprint.
Tilting and upending
Frames that turn a part over, or stand a weldment up, without re-rigging it halfway.
Drums, totes and containers
Handling attachments for the thing your plant moves every day and nobody sells a part for.
Vacuum and magnet
Where the load has nowhere to hook to, and the lift has to grab a surface instead.
Something with no name
A fixture for one part, on one line, in one building. We build more of these than anything.
How we work
A drawing is a question, not an order
Send a sketch and you are not committing to anything. Plenty of what we quote comes back as 'a stock part does this' — which costs you nothing and saves you a fabrication lead time. When it genuinely needs building, it is designed to ASME BTH-1, signed off by our engineer against your actual lift, proof load tested, and shipped with its certificate.
We do not need a finished print
Dimensions on a phone photo are fine. If the only drawing that exists is the one you just made on the back of a work order, that is the one to send — our engineer turns it into something buildable, and that is the part you are paying for.
Your drawing stays yours
It goes to the people quoting your job and nowhere else. We do not post customers’ parts, and we do not use one customer’s fixture to quote another.
We also fix what we did not build
If you already own the device and it is cracked, bent, or needs re-rating for a heavier load, send a photo of that instead. That is the same shop.
Summit Lifting Devices · a division of Sharrow Lifting Products
If it is one of these three, start there instead
A lifting beam, a spreader bar or a triangle beam draws itself to scale as you type and sends a dimensioned spec straight through. Quicker than describing one here.
Build‑a‑Beam
One hook above, pick points below, for when you have almost no headroom to work with. Sizes the channel to the load as you go.
Half a ton to 10 tons · 24" to 240" span
Start buildingBuild‑a‑Spreader‑Bar
Two legs down to the ends of a bar, so the lift squeezes it instead of bending it. Lighter over a long spread, but it wants real headroom.
A quarter ton to 40 tons · 24" to 240" spread
Start buildingBuild‑a‑Triangle‑Beam
A beam cut from flat plate: a hole at the top for the hook, holes along the bottom for the load. For lugs the stocked sizes do not match, or more than two pick points.
A quarter ton to 20 tons · 12" to 60" pick spacing
Start buildingFully customSomething else entirely
C-hooks, coil and sheet handling, tilt frames, a fixture for one awkward part. Send a drawing, a CAD file, or a photo of a sketch and our engineer takes it from there.
A napkin sketch is enough to start
Send a drawingSummit does not make everything, and custom is not always what you want. If a catalogue part already fits, it comes with a part number, a published capacity and no engineering lead time — we carry Caldwell, Peerless, M&W and Renfroe too, and we will say so.

